Wednesday 13. November 2019
Sitemap
Powel Descaler - electronic water conditioner - logo
  Home Presentation
   Introduction       How it works       Products       Buy       Installation       Download       Dealers Application       Distributors       Contact   
DESCALER HE 15
DESCALER HE 25
DESCALER HE 50
DESCALER Pro Series
Recommendation for
   installation

DESCALER HE 50

INSTALLATION INSTRUCTIONS

INSTALLATION
As the picture shows the installation of DESCALER HE50 water softener is very simple and does not require any plumbing or fitting works. The installation consists of wrapping two field coils around the water-supply pipe, fixing the box onto the wall and connecting the coil and the box.

Installation of the coil:
Wrap the coils (11 turns each) around the horizontal or vertical pipe while the distance between the coils is 15 cm (6") and the distance between the ends of the coils and the bends, valves, joints, etc. must be minimum three times the outer diameter of the pipe in order to avoid unwanted water turbulence in the place where the coils are wound. The direction of the winding of the coils is the same. Tightly fix the ends of the coil with plastic bands.

If practicable, the coil wire leads can be shortened to the lengths of 20 cm the following way:
Unscrew the plastic cover of the banana pin, loosen the worm and pull out the wire. Shorten the wire to the required length, remove the insulation at its end (about 7 mm), insert the wire back into the banana pin and tighten the worm. Finally, screw the plastic cover onto the banana pin.


DESCALER scale protection unit


Installation of the box:
Use the drilling jig and a sharp tipped object to mark holes not far from the coils. Then drill the holes of the diameter of 6 mm. Put wall plugs into the holes and drive in screws so that their heads jut out over the wall by about 5 mm. There are openings on the rear cover of the electronic unit; put the box on the wall the way that the screw heads get through the openings and slide the box downwards.

PUTTING INTO OPERATION
Plug the connectors into the outlets of the unit. The wire leads should not be too tight and they must not be entwined together.
The unit is powered by 12 V= direct regulated current from the power adapter. Connect the power supply to the unit and plug the adapter into an electrical socket. The green LED (POWER) indicates the proper functioning.
The red LED (ERROR) is blinking after the coil circuit was interrupted, for example, after unplugging the connector or if there is no signal in the output connectors (failure).
It is necessary to place the adapter in the environment where there is no threat of spattering water. In case there is the possibility of spattering water, it is necessary to place the adapter into the case IP 54.

All prices include
tax and shipping
e-shop




About your water: Hard water | Water hardness | Limescale | Water treatment | Electronic Water Conditioner | Water Conditioner | Water Softener |
webdesign by Shuster & Ori
Copyright ©1999 - 2005. All rights reserved